A clogged shower head can significantly impact the water flow and harm your shower's visual appeal. If you'd like to fix this problem and get your rainfall shower head working as it used to, you would need to get through the correct steps to help you reach that ultimate goal. All you need to do is put in some effort and dedication, and you will realize some impressive results.
Once you unclog the shower head, you will notice some significant improvement in its performance. A clean shower head allows for improved water flow and better shower experience. Solving a clogged shower head won’t take you that long. Read through for our ultimate guide.
Step 1: Turn off Water Supply
Most people who have tried cleaning the clogged shower head may think that turning off the water shower is enough, but that's not all. The shower valve doesn't stop water from getting into the pipes. You are going to make a total mess if you don't correct this. Instead, locate the main shut-off valve to lock out any water supply to the entire faucet system.
Step 2: Remove The Shower Head
Now that you have the water cut off, you can remove the shower faucet for cleaning. The shower head is easily removable by hand, but if t has been in place for long, you'll need a wrench. Once you remove it, damaged or worn parts are easily noticeable. If you see any, you should resolve to replace them.
If the shower faucet is stuck, and the wrench isn't sufficient, continuously apply pressure for some time, and it will eventually come out. You may place a towel on the wet shower head as you try to remove it. After removing and disassembling it, place all these removable parts on a towel to prevent them from getting lost.
Step 3: Use Hot Water and Vinegar
Over time, mineral and mildew buildup on the shower faucet prevents it from working effectively. Fortunately, with hot water and vinegar, you can quickly restore your shower head's performance. Pour three cups of vinegar and two for water in a pot and heat it for some minutes using a stove.
Once this solution starts boiling, turn off the heat. Proceed to fully immerse the shower head and let it sit there for 12 to 24 hours, depending on the extent of discoloration. Let the shower head soak in the solution; it will dissolve and remove the buildup. Thereafter, remove it from the solution and use a brush to scrub it. What’s left is putting back the shower head and turning on the water supply.
In conclusion, unless you regularly clean your shower head, mineral and mildew buildup can clog various parts of the shower system, decreasing its effectiveness. This entire process will take you less than two hours. Even though cleaning the shower head may take up some time, you will be impressed by the results once you get the job done. Last but not least, instead of waiting to see discolorations in your shower head, consider regular cleaning-preferably every three months- to prevent the clogging.